2n Fixed line replacement with 2N SmartGate - Manual Bedienungsanleitung PDF herunterladen (Seite 57)

Voice function

4.1

Incoming call on FXO interface

1.   detects a ringing signal and immediately interconnects it to

FXS interface  the phone starts to ring.

2. The CLIP transmitting must provide connected PBX.

3. If you hook off the phone the call is established.

Automatic Call ("BabyCall")

If the BabyCall function is enabled on FXS interface, a pre-programmed timeout

is counted down after off- 2

SmartGate signals dialing end and starts to establish a call to the pre-programmed

number using GSM network automatically  from now behaves as

if a standard outgoing call to GSM had been established. Any dialing during the

BabyCall timeout cancels this function and a standard outgoing call can be made.

ME- Mobility Extension

ME function takes place during ringing on FXS interface if   is

programmed as DialThru gateway.

Fill in telephone number for ME function and number of rings to ME function start

on FXO routing table sheet.

1.   detects a ringing signal and immediately interconnects it to

FXS interface  the phone starts to ring.

2. If there is no call connection before the pre-programmed number of rings, 

SmartGate simultaneously establishes call to GSM network. Some timeout take

place between GSM call establishing start and ringing of mobile phone.

3. As long as detects ringing on FXO interface, connected analog

and GSM phones ring.

4. You can receive the call on analog line as well as on your mobile phone.

5. During call received on mobile phone you can send FLASH to PBX, for special

PBX functions, by preprogrammed DTMF code.

If you want repeatedly temporarily disable and afterwards enable the ME

function, fill in Password for ME activation/disabling. If password is filled in:

1. Hook off the phone.

2. For temporarily disabling the function dial the password and confirm by

For activation the function dial the password and confirm by .

3. Hang up.

Tariff pulses 16 or 12 kHz

has tariff pulse transmitter on FXS interface. You can use tariff

pulses for outgoing call pricing.   offer pseudotariff only  tariff

           ansmitted

according to programmed parameters and call duration. You must program specific

parameters in FXS routing table to set tariff metering for different prefixes of dialed

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 88 89

Keine Kommentare

2n Fixed line replacement with 2N SmartGate - Manual Bedienungsanleitung Seite 57