2n Fixed line replacement with 2N SmartGate - Manual Bedienungsanleitung PDF herunterladen (Seite 39)

Table of Parameters

3.2

„BabyCall“ – Automatic call

BabyCall number Function No.: 280

If is programmed as FXO gateway, parameter defines a number

to be dialed for the automatic call function. If this item is blank, the function is

disabled.           

interfaces FXO and FXS are connected and dialing to PSTN over FXO interface is

possible.

Setting options: 0-20 characters (0-9,*,#,+)

Default setting: blank

BabyCall timeout [s] Function No.: 281

If   is programmed as FXO gateway, parameter defines time

between line Off-Hook and automatic call beginning (if enabled). During this

timeout   waits for dialing that cancels the automatic call. You

can make standard call if the BabyCall function is enabled.

Setting options: 0-255 s

Setting step: 1 s

Default setting: 0 s

Mobility extension FLASH

Mobility Extension FLASH DTMF code Function No.: 240

Fill in DTMF code to enable GSM FLASH function. If   receive

DTMF dialing corresponding to filled code during GSM - FXO call, it generates

FLASH to FXO interface.

Setting options: 0-4 characters (0-9,*,#)

Default setting: blank

FLASH length [ms] Function No.: 241

Time of current loop interruption (line On-Hook) during FLASH.

Setting options: 100-1500 ms

Step: 100 ms

Default setting: 100 ms

FXS routing table parameters

All parameters related to the dialed number and call routing are arranged in three

routing tables. Each table pertains to one interface: FXS, FXO and GSM.

According to the prefix of dialed number on FXS interface you can:

 Bar the number to be dialed - the calling subscriber tone;

 Route the call to GSM network, or to PBX through the FXO interface;

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 88 89

Keine Kommentare

2n Fixed line replacement with 2N SmartGate - Manual Bedienungsanleitung Seite 39