2n M2M Solution 2N SmartCom - User Manual 1.9.0 Bedienungsanleitung PDF herunterladen (Seite 68)

682N TELEKOMUNIKACE a.s., www.2n.cz

Figure: Communication Settings

Having selected a port, set the communication parameters to adjust communication

rates and signal transmission parameters for the serial port. The fact2N SmartCOM

ory values are set here by default. Refer to the figure Communication Settings

above.

No password is requested by default for the RS-232 port and so nothing has to be filled

in. Passwords may be different for different terminals. If a password is requested, enter

the password into the dialogue window displayed during the connecting process. The

last main toolbar button helps you from the terminal connected -Load configuration

the application gets connected and reads out all relevant data.

Tip

The application connects to the selected terminal, identifies the

RS-232 mode (DATA or COMMAND), switches the port as necessary,

reads out the data, switches the port into the original mode and

terminates communication. This gives the other users continuous

access to the terminal.

The section displays the most important information on the given device.State

The IP address, serial number, firmware version, logged-in provider and signal level

are displayed. The SIM ICCID (Integrated Circuit Card ID) is displayed, which is not the

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 148 149

Keine Kommentare

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Bedienungsanleitung Seite 68