2n M2M Solution 2N SmartCom - User Manual 1.9.0 Bedienungsanleitung PDF herunterladen (Seite 33)

332N TELEKOMUNIKACE a.s., www.2n.cz

Enter the command to make return the IP addressed assigned2N SmartCOM

by the provider.

at^sccfg="server_ip","90.182.112.54"

Enter the command to set the IP address of the server to which 2N SmartCOM

should connect in mode 1.

at^sccfg="server_port","1564"

Enter the command to set the server port to which should2N SmartCOM

connect in mode 1.

at^sccfg="auth_pass","xJ32ppp_v1"

Enter the command to set the authorisation password for the above specified

server.

at^sccfg="sim_pin","1156"

Enter the command to set the PIN to be entered upon power up.

at^sccfg="auth_ip",1

Switch on / off access authorisation according to IP addresses.

at^sccfg="encrypt",1

Set the encryption mode for - server communication. The2N SmartCOM

setting options are 0–2.

Mode 0 DISABLED – encrypts no data.2N SmartCOM

Mode 1 OPTIONAL – encrypts data if the counterparty2N SmartCOM

requires so.

Mode 2 FORCED – encrypts all outgoing data.2N SmartCOM

at^sccfg="encrypt_key","E2978FE2978FE2978FE2978FE2978F20"

Set the encryption key using 32 valid (hexa) characters, which makes 16 ASCII,

via the ControlPanel.

at^sccfg="save"

Enter the command to save changes.

at^sccfg="restart"

Enter the command to restart .2N SmartCOM

at^sccfg="srestart"

Save the changes and restart 2N SmartCOM.

at^sccfg?

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 148 149

Keine Kommentare

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Bedienungsanleitung Seite 33